Alarm occurrence indication
When an occurrence notification occurs, a popover will be displayed. When the [x] button is clicked, the
popover will disappear. (
®
“1.4 Action at an alarm occurrence”)
Note
•
Since the alarm occurrence indication is not coupled to recording images to the SD memory card,
forwarding E-mails, or other operations, check the settings of each operation separately.
Camera control panel - SD memory card − [Rec. on SD]
This item is available only when “Manual” is selected for “Save trigger” on the [SD memory card] tab.
(
®
Click the [Start] button to manually record images on the SD memory card. Refer to “1.3 Record images
on the SD memory card manually” for descriptions of how to manually record images on the SD memory
card.
Camera control panel - Volume - [Mic input volume (Camera to PC)]
This item is available only when the settings are as follows. (
®
“3.6.5 Configure the settings relating to
•
When “Mic input” is selected for “Audio transmission mode”
•
When “AAC-LC” is selected for “Audio input encoding format”
The mic input volume can be adjusted in 4 steps (Off/Low/Middle/High) by clicking the
button or the
button or by moving the volume cursor.
When the mic input button
is clicked, the mic input (Camera to PC) will be turned on/off.
Note
•
When “Audio volume control mode” is set to “Adjust Mic input” in the setup menu, the volume cursor
cannot be operated when using “Audio recording” or “Audio detection”.
•
When the camera is restarted, the adjusted volume level (for the reception) will return to the level
that had been set on the [Audio] tab on the setup menu. (
®
“3.6.5 Configure the settings relating
•
If multiple camera browsers are open at the same time on the same computer, audio cannot be
heard from the camera browsers that were opened later. Please only access 1 camera at a time.
•
If the network communication is unstable, audio input may stop. In this case, resume the mic input
by turning the mic input button off and on.
Camera control panel - [Brightness]
The brightness is adjustable from 0 to 255. Click the
button to make the image brighter, or click the
button to make the image darker. When the
button is clicked, the setting will be reset to the default.
Note
•
If you adjust the brightness while recording, the recorded image may be affected.
Operating Instructions
15
1 Operations
