IMPORTANT
•
Before deleting the valid CA certificate (security certificate), confirm that there is a backup file of the
CA certificate (security certificate) on the PC or another media. The backup file of the CA certificate
(security certificate) will be required when installing the CA certificate (security certificate) again.
Note
•
After changing the connection setting, access the camera again by after waiting a while according to
the changed setting (“http://IP address of the camera” or “https://IP address of the camera”).
•
When the camera is accessed using the HTTPS protocol, the refresh interval and frame rate of images
may be lower.
•
When the camera is accessed using the HTTPS protocol, it may take time to display images.
•
When the camera is accessed using the HTTPS protocol, the images may be distorted or audio may
be interrupted.
•
The maximum number of concurrent access user varies depending on the maximum image size and
transmission format.
3.10.2.6 Configure the settings relating to DDNS
To access this camera via the Internet, it is necessary to configure the settings for the DDNS function.
Refer to “3.10.4 How to configure the settings relating to DDNS” for how to configure the settings relating to
DDNS.
[Area]
Select the region where the camera is installed.
Japan/Global
Note
•
If the camera is used in Japan, select “Japan”. If the camera is used outside of Japan, select
“Global”. The “Viewnetcam.com” service that is displayed when “Global” is selected cannot be used in
Japan.
[Service]
Select the DDNS service to determine whether or not to use DDNS.
•
Off:
Does not use the DDNS function.
•
Viewnetcam.com:
Uses the “Viewnetcam.com” service.
•
Dynamic DNS Update:
Uses Dynamic DNS Update (RFC2136 compliant) without the DHCP cooperation.
•
Dynamic DNS Update(DHCP):
Uses Dynamic DNS Update (RFC2136 compliant) with the DHCP
cooperation.
•
Default:
Off
Note
•
When using Dynamic DNS Update (RFC2136 compliant), refer to the network administrator for whether
or not to cooperate with the DHCP.
3.10.2.7 Configure the settings relating to SNMP
The settings relating to SNMP can be configured on this page. It is possible to check the status of the camera
by connecting to the SNMP manager. When using the SNMP function, contact the network administrator.
SNMP agent setting
[SNMP version]
144
Operating Instructions
3 Detailed Settings
