3.8.3 Configure the VMD settings [VMD area]
Click the [VMD area] tab on the “Alarm” page. (
®
“3.2.1 How to display the setup menu”, “3.2.2 How to operate
the setup menu”)
The video motion detection areas can be set on this page.
Up to 4 areas can be set. When motion is detected in the set area, it will be regarded as an alarm.
IMPORTANT
•
The alarm occurrence indication button (
®
“1.1.2 About the “Live” page”) will be displayed when motion
is detected by the VMD function.
•
The alarm occurrence indication button is also displayed when detecting with the audio detection alarm
or when receiving a command alarm.
•
Depending on the network environment, notification may be delayed.
•
After configuring the VMD area, the VMD area may move out of alignment when “Image rotation” of
the [Basic] tab is changed. Make sure to check the VMD area after changing the “Image capture
mode” setting.
•
The motion detection function is not the dedicated function to prevent thefts, fires, etc. We are not
responsible for any accidents or damages that may occur.
•
Be aware that a VMD alarm may occur due to changes in the brightness of the whole image depending
on the status of the object when “On” is selected for “Intelligent auto”. In such a case, set either of the
following:
–
Select “On” for “Light detection control” of VMD.
–
Move the slider of “Detection sensitivity” of the VMD area in the “-” direction.
110
Operating Instructions
3 Detailed Settings
