HunterLab EasyMatch QC, Руководство пользователя

Страница: 278 / 366

EasyMatch QC User’s Manual Version 2.1
UltraScan VIS 11G-51
UltraScan VIS Specifications
The specifications and characteristics of your instrument are given in this section.
Note: Every attempt at accuracy is made, but specifications are subject to change without notice.
For best performance, your instrument should be placed where there is ample work space with medium
or subdued illumination and no drafts. For optimum results, a clean, air-conditioned area is
recommended with a relative noncondensing humidity of 20-80% [10-90% for sensor only] and
relatively constant temperature not exceeding 90°F (32°C) [104°F (40°C) for sensor only]. For
specification performance, the recommended temperature range is 70-82°F (21-28°C).
The instrument should be connected to a stable, instrument-grade power line. If other equipment is
connected to the same power line, a transient power surge may be produced when the other equipment is
turned on. If this happens, restandardize the instrument before making measurements. HunterLab
recommends using a line conditioner with a minimum 600 VA rating and a battery back-up system.
Physical Characteristics
Optical Sensor: approximately 16.5” (42 cm) wide, 11” (27.9 cm) high, 19.6” (49.8 cm) deep, 45 lbs.
(20.4 kg) not including the sample clamp.
Computer system: depends upon system selected. Refer to manufacturer’s documentation for
information.
Communications interface: RS-232C serial DB-9 or USB.
Environmental Requirements
Operating Temperature 50°F - 104°F (10°C - 40°C)
Operating Humidity Up to 90% relative, non-condensing
Storage Temperature -5°F - 150°F (-21°C - 66°C) for up to three weeks
Power Required
Voltage - 100-240VAC, 47/63 Hz.
Single Phase.
100 VA maximum.
Fuse - 3A, SB (250 V).
Installation Category (Over Voltage) - II.