• Authentication
• Authentication Type
• User ID
• Password
NOTE:
You can change the password in the menu.
4.
Enter assigned infrastructure groups.
5.
Click
OK
.
Configuring remote connections
Prerequisites
Consult "Windows prerequisites for agentless connections" or " SSH prerequisites for agentless
connections" in the
HPE XP7 Automation Director Installation and Configuration Guide
for details on
setting up a remote connection.
When specifying a range of addresses (i.e., X.X.X.A to X.X.X.B) for IPv4, use a hyphen (-) as shown in
the following format:
Format: X.X.X.A-B
Correct examples:
192.168.1.1-255 (from 192.168.1.1 to 192.168.1.255) 192.168.1.5-15 (from 192.168.1.5 to 192.168.1.15)
Incorrect example:
192.168.1-2.4
When specifying a range of addresses for IPv6, use a network preface that conforms to RFC 2373.
Procedure
1.
On the
Administration
tab, click
Connection Settings > Agentless Remote Connection
.
2.
Click
Add
to add a connection. To edit a connection, select the check box next to the connection and
click
Edit
. Enter or edit the following information:
•
Method
: Select Host Name, IPv4, or IPv6
•
IP Address/Host Name
: Enter an IP address if you are using IPv4 or IPv6, or a enter a host name.
•
Service Group
: Select a Service Group for access purposes.
•
Authentication
: Enabled by default. When disabled, access to the host is anonymous.
•
Protocol
: If authentication is used, select Windows, SSH, or Telnet. Depending on the protocol you
have selected, a dialog box is provided for specifying the authentication method along with any
necessary passwords.
◦
User ID
: Required if authentication is used.
◦
Password
: Required if authentication is used.
◦
Super User's Password
: Required if Protocol is SSH or Telnet.
72
Configuring remote connections
