IMPORTANT:
If a cable will not be connected to the SFP transceiver, install a dust cover in the
SFP transceiver.
a.
On the SFP transceiver, pivot the retaining clip closed.
b.
Slide the SFP transceiver into the port slot until fully inserted.
12.
Reconnect the cable in the same location recorded on the label.
Verification
13.
Verify that the replacement SFP transceiver has been successfully installed.
On the port with the replacement SFP transceiver, verify that the Link Status LED is solid green and
the Port Speed LED is flashing amber.
14.
From the Service Console interface, verify that the
State
of the component and the storage system
are
Normal
(green).
15.
After the component replacement, initiate
Check Health
on the storage system.
a.
From the Service Console interface, select
Systems
.
b.
Select
Actions
>
Check health
.
16.
If significant time is left in the maintenance window, end the
Maintenance Mode
.
a.
From the Service Console interface, select
Systems
.
b.
Select
Actions
>
Set maintenance mode
.
c.
To end the maintenance window associated with the replacement, click
X
.
The flow of support information and local notifications of system alerts will be sent to Hewlett
Packard Enterprise again.
17.
Follow the return instructions provided with the replacement component.
Switch replacement
The Brocade 6510 Switch is a direct-current component supported for the HPE 3PAR StoreServ 8000
Storage system.
WARNING:
Since there is a risk of injury from electric shock or high energy levels, only a certified
electrician who knows about the procedures, precautions, and hazards associated with direct-
current (DC) power should perform the power wiring, cabling, routine maintenance, and service of a
storage system installed in a direct-current power environment. Hewlett Packard Enterprise and
partner service personnel are not authorized to perform DC power wiring or cabling.
IMPORTANT:
The storage system ordered for installation in a direct-current (DC) power
environment requires the installation of DC-specific components. Use of components with
alternating-current (AC) power in the DC storage system is prohibited.
IMPORTANT:
The direct-current components are qualified and supported only with a direct-current
HPE 3PAR StoreServ 8000 Storage system running HPE 3PAR OS 3.3.1 and later versions.
Service
55
