NOTE:
The metal bracket where the sensor resides is part of the sensor kit and must be installed
before installing a sensor for the first time. Installing a front fan or some full-length expansion cards may
require that you install a front fan holder/card guide instead of the mounting bracket. See
Installing the
front fan assembly on page 104
for details on installing the side access panel sensor with the fan
assembly.
1.
Power down the workstation (see
Predisassembly procedures on page 75
).
2.
Disconnect power from the workstation (see
Predisassembly procedures on page 75
).
3.
Remove the side access panel (see
Removing the side access panel on page 78
).
4.
Install the sensor by sliding the sensor into the slot provided for it in the fan holder/card guide (1),
as shown in the following illustration.
Figure 5-7
Installing the side access panel sensor (fan holder mounting)
5.
Carefully route the sensor cable along the bottom of the drive bay so that it is not pinched by the
fan holder/card guide and plug the sensor cable into the HSENSE connector on the system board
(2).
CAUTION:
Clamping a cable between the card guide and the chassis might damage the cable.
NOTE:
To locate system board components, see the service label on the side access panel.
6.
Make sure that the cable will not interfere with the expansion cards.
ENWW
Removing and installing components
81
Содержание Z400 - Workstation
Страница 1: ...HP Z400 Workstation Maintenance and Service Guide ...
Страница 4: ...iv About this guide ENWW ...
Страница 12: ...Index 241 xii ENWW ...
