For AUTO (default), the print server uses auto-negotiation to configure itself with the highest link speed and communication
mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the detected link speed of
the hub/switch port. (A 1000T half-duplex selection is not supported.)
upgrade:
To configure one or more Jetdirect print servers with the name and location of a firmware upgrade file.
CAUTION
Ensure that command parameters are properly entered and that the upgrade file is a higher version
than the currently installed version. The print server will attempt to upgrade when the upgrade file contains a
higher version than the installed version.
The command format is:
upgrade: <TFTP server IP> <Version> <Product Number> <Filename>
where,
<TFTP Server IP>
is the IP address of the TFTP server,
<Version>
specifies the firmware version of the upgrade file,
<Product Number>
specifies and must match the product number of the print server,
<Filename>
is the path and filename of the firmware upgrade file.
status-page-lang:
Specifies the page description language (PDL) that the print server will use to send the Jetdirect configuration/status page
to the printer.
●
Auto (default): The PDL is auto-detected when the print server is powered on or after a cold-reset.
●
PCL: Hewlett-Packard Printer Control Language
●
ASCII: Standard ascii characters
●
HPGL2: Hewlett-Packard Graphics Language (v2)
●
PS: PostScript language
Support
support-name: (or support-contact:)
Typically used to identify the name of a person to contact for support of this device.
support-number:
Typically used to specify a phone number or extension to call for support of this device.
support-url:
A Web URL for product information on this device over the Internet or an intranet.
tech-support-url:
A Web URL for technical support over the Internet or an intranet.
Using DHCP (IPv4)
Dynamic Host Configuration Protocol (DHCP, RFC 2131/2132) is one of several auto configuration
mechanisms that the HP Jetdirect print server uses. If you have a DHCP server on your network, the
HP Jetdirect print server automatically obtains its IP address from that server and registers its name
Table 3-2
TFTP Configuration File Parameters (continued)
ENWW
IPv4 Configuration
35
Содержание Jetdirect J7974E
