HP Jetdirect J7974E, Руководство администратора

Страница: 145 / 186

Error Code and Message Description
5E DHCP LEASE RELEASED The lease for DHCP-configured parameters, including the IP address, have been
released through a manual configuration method, such as through the printer's control
panel.
5F WINS REGISTRATION FAILED Attempts to register the print server's name on the WINS server failed. Check for
duplicate names, or verify the WINS server configuration.
61 AUTO IP CONFIGURED An IP address could not be retrieved over the network. The print server will default to
an IP address using link-local addressing in the form 169.254.x.x.
62 DEFAULT IP CONFIGURED An IP address could not be retrieved over the network. The print server will default to a
legacy default IP address 192.0.0.192.
63 AUTO IP IN PROGRESS The print server is automatically assigning an IP address using link-local addressing in
the form 169.254.x.x.
64 INVALID PASSWORD An invalid password was specified through TFTP. Verify that the password consists of
a maximum of 16 printable characters.
83 DISCONNECTING FROM
SERVER The server has been shut down because of a configuration change or reset request.
This message automatically clears after a few seconds, unless the printer is offline, is
in an error state, or is servicing another I/O port or another network protocol.
84 DHCP LEASE TIMERS
ADJUSTED The print server detected a DHCP lease error due to one of the following conditions:
●
Renew time is less than 30 seconds.
● Rebind time is less than 52 seconds.
●
Rebind time is less than, or equal to, the Renew time.
● The lease duration is less than, or equal to, the Rebind time.
86 FOR MULTILANGUAGES
UPGRADE AGAIN When upgrading a supported print server that contains a firmware version prior to X.
24.00, it will be necessary to perform the firmware upgrade again if you want the print
server to support management tools (for example, the embedded Web server) using
non-English languages.
F1 TRYING TO CONNECT TO
SERVER The HP Jetdirect print server is trying to connect to the NetWare server(s). This is a
normal message. Wait until either the connection is established or another status
message appears.
F2 TFTP IN PROGRESS The print server is attempting to use TFTP to obtain TCP/IP configuration settings over
the network.
F3 BOOTP/RARP IN PROGRESS The print server is attempting to use BootP or RARP to obtain TCP/IP configuration
settings over the network.
F4 BOOTP/DHCP IN PROGRESS The print server is attempting to use BootP or DHCP to obtain TCP/IP configuration
settings over the network.
Security Configuration Page
An enhanced Security page can be printed from the Jetdirect menu accessed through the printer control
panel. A typical Security page is illustrated below.
Table 8-12 Error Messages (continued)
ENWW Security Configuration Page 135