Table 8-11
DLC/LLC Configuration Information
Message
Description
STATUS:
Indicates the current DLC/LLC protocol status.
READY: Indicates the HP Jetdirect print server is awaiting data.
DISABLED: Indicates that DLC/LLC was manually disabled.
INITIALIZING: Indicates that the print server is registering the node address or name.
An additional status message may also be displayed.
An error code and message is displayed if the print server is not ready. For more
information, see
Table 8-12 Error Messages
.
Error Messages
Error codes and messages that may appear in the Status sections of the Jetdirect configuration page
are described in
Table 8-12 Error Messages
.
Table 8-12
Error Messages
Error Code and Message
Description
02 LAN ERROR - INTERNAL
LOOPBACK
During self-test, the HP Jetdirect print server detected an internal loopback test error.
The print server may be faulty. If the error persists, replace the HP Jetdirect print server.
03 LAN ERROR - EXTERNAL
LOOPBACK
The HP Jetdirect print server is incorrectly connected to your network or is defective.
Make sure your HP Jetdirect print server is correctly attached to your network. In
addition, check the cabling and connectors.
06 ENCRYPTION REQUIRED
Encryption is required on this network, but the print server cannot communicate on the
network due to improper encryption settings. Check the encryption settings configured
on the print server.
07 LAN ERROR - CONTROLLER
CHIP
Check the network connections. If the connections are intact, run the power-on self-test:
turn the printer off, then on again. If the error persists, replace the HP Jetdirect print
server.
07 AUTHENTICATION FAILED
The Jetdirect print server could not access the network because of an authentication
error. The error depends on the authentication method used.
Verify the authentication method and settings on the print server.
08 LAN ERROR - INFINITE
DEFERRAL
There is a network congestion problem.
NOTE
If the print server is not connected to the network, this error cannot
occur.
08 AUTHENTICATION IN
PROGRESS
Link-level authentication is in progress.
09 LAN ERROR - BABBLE
Check the network connections. If the connections are intact, run the power-on self-test:
turn the printer off, then on again. If the error persists, replace the HP Jetdirect print
server. For replacement instructions, see the hardware installation guide for your print
server.
0A LAN ERROR - NO SQE
(Wired Ethernet) Check the network connections. If the connections are intact, run the
power-on self-test: turn the printer off, then on again. If the error persists, replace the
HP Jetdirect print server.
ENWW
HP Jetdirect Configuration Page
129
Содержание Jetdirect J7974E
