For Ethernet print servers, the LAA address must start with hexadecimal X2, X6, XA, or
XE, where X is any hexadecimal digit 0 through F.
The default address is the factory-assigned address.
xml-services-conf
Enable or disable access by HP Web service applications to XML-based data on the HP
Jetdirect print server.
1: (Default) Enable
0: Disable
ws-discovery-conf
Enable or disable the Microsoft Web Services Dynamic Discovery (WS Discovery)
protocols on the print server.
1: (Default) Enable
0: Disable
1000t-ms-conf
Use this command to configure the print server as a master or slave device on a 1000T
network.
AUTO or 0: (Default) A master/slave configuration is automatically sensed and assigned.
MASTER or 1: The device is configured as a 1000T master device.
SLAVE or 2: The device is configured as a 1000T slave device.
1000t-pause-conf
This command is used for flow control of inbound and outbound data.
OFF
or
0
: (Default) Flow control is disabled.
AUTO
or
1
: Flow control is configured through auto-negotiation with the network switch.
RCV
or
2
: Flow control is enabled only for data received from the network.
TRANS
or
3
: Flow control is enabled only for data transmitted to the network.
TXRX
or
4
: Flow control is enabled for both received and transmit data.
link-type
(For wired 10/100/1000T Ethernet) Sets the print server's link speed (10, 100, 1000 Mbps)
and communication mode (Full- or Half-Duplex). The available link-speed selections
depend on the print server model. The selections that may be displayed are listed below.
CAUTION
If you change the link setting, network communications with the print
server and network device may be lost.
AUTO
(default):
1000FULL
: 1000 Mbps, full-duplex operation.
100AUTO
: Limits auto-negotiation to a maximum link speed of 100 Mbps.
100FULL
: 100 Mbps, full-duplex operation.
100HALF
: 100 Mbps, half-duplex operation.
10FULL
: 10 Mbps, Full-duplex operation.
10HALF
: 10 Mbps, half-duplex operation.
Support
Web JetAdmin URL
(Read-only parameter) If HP Web Jetadmin discovers this device, the URL to access HP
Web Jetadmin will be specified.
Table 3-3
Telnet Commands and Parameters (continued)
ENWW
IPv4 Configuration
53
Содержание Jetdirect J7974E
