HP jetdirect 250m, Руководство пользователя

Страница: 101 / 295

TCP/IP Configuration
This section covers the following topics:
●
Introduction
●
TCP/IP Overview
●
Using BOOTP/TFTP
●
Using DHCP
●
Using RARP
●
Using the arp and ping commands
●
Using Telnet
●
Using the embedded Web server
●
Moving to another network
Introduction
To operate properly on a TCP/IP network, the HP Jetdirect
print server must be configured with valid TCP/IP network
configuration parameters, such as an IP address. Depending
on your printer and system, this can be done in the following
ways:
Note When shipped from the factory, the HP Jetdirect print
server has no IP address. If the HP Jetdirect print
server is not configured with a valid IP address within
two minutes after power up, a factory default value of
192.0.0.192 will be automatically assigned. This
address must be reconfigured with a valid address for
use on your TCP/IP network. For more information
on TCP/IP networks, see TCP/IP Overview.
• Using your printer installation software or the HP
Jetdirect print server installation software on supported
systems. For more information see "
HP Software
Solutions Summary ".
• By downloading the data from a network-based server
using BOOTP (Bootstrap Protocol) and TFTP (Trivial File
Transfer Protocol) each time the printer is turned on. For
more information, see "
Using BOOTP/TFTP ".
Note The BOOTP daemon, bootpd, must be running on a
BOOTP server that is accessible by the printer.