![background image](http://html.mh-extra.com/html/hp/jetdirect-250m/jetdirect-250m_user-manual_163690126.webp)
get-community-name:
Specifies a password that determines which SNMP GetRequests the
HP Jetdirect print server will respond to. This is optional. Specifies a
password for SNMP GetRequests sent to the HP Jetdirect print
server. This password is optional. If a user-specified get community
name is set, the print server will respond to either a user-specified
community name or the factory-default. The community name must
be ASCII characters. The maximum length is 255 characters.
set-community-name:
Specifies a password that determines which SNMP SetRequests
(control functions) the HP Jetdirect print server will respond to. The
community name of an incoming SNMP SetRequest must match the
print server's "set community name" for the print server to respond.
SetRequests must come from hosts that are configured in the print
server's host access list. Community names must be ASCII
characters. The maximum length is 255 characters.
auth-trap:
Configures the print server to send (on) or not send (off) SNMP
authentication traps. Authentication traps indicate that an SNMP
request was received, but the community name check failed. The
default is "on."
trap-dest:
Enters a host's IP address into the HP Jetdirect print server's SNMP
trap destination list. The command format is:
trap-dest:
ip-address
[community name] [port number]
The default community name is 'public'; the default SNMP port
number is '162'. The port number cannot be specified without a
community name, otherwise the port number will become the
community name.
If a 'trap-community-name' command is followed by 'trap-dest'
commands, the trap community name will be assigned to those
entries unless a different community name is specified in each 'trap-
dest' command.
To delete the table, use 'trap-dest: 0'.
If the list is empty, the print server does not send SNMP traps. The
list may contain up to five entries. The default SNMP Trap
Destination List is empty. To receive SNMP traps, the systems listed
on the SNMP trap destination list must have a trap daemon to listen
to those traps.
trap-community-name:
Community name (password) included with SNMP traps that are
sent by the HP Jetdirect print server to a host computer. The default
community name is
public
. Community names must be ASCII
characters. The maximum length is 255 characters.
IPX/SPX
ipx-config:
Enables or disables IPX/SPX protocol operation on the print server:
0 disables, 1 (default) enables.
ipx-unit-name:
Содержание jetdirect 250m
