HP 8530A, Руководство по эксплуатации и программированию, Страница: 260 / 439

Disc Functions
menu by entering the actual address followed by the 4 x1 5 key . Alternatively , you can change
the HP-IB address switches on the external disc drive . Turn the disc drive O, then On if
you change its HP-IB switch settings .
4.
Press 4
DISC
5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
STORAGE IS EXTERNAL then
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SET UP DISC to select the unit and volume
number (explained below).
5. If using a disc drive that has more than one drive mechanism (unit), you must select the
specic drive you want to use . The default is 0 (usually the left drive on a dual oppy drive ,
or the hard disc in a oppy/hard disc combination drive).
If you want to use the right-hand drive (in a dual oppy system), or the oppy drive in a
hard disc/oppy drive:
Press 4 DISC 5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SET UP DISC
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
DISC UNIT NUMBER 4 1 5 4 x1 5
Refer to the disc drive's operating manual to verify the unit numbers used by your drive .
6. Hard drives can be partitioned into one or more \volumes ." V olumes act like separate
drives , even though they are , in fact, part of the same physical disc . A control wheel on the
back of the hard disc selects the number of volumes that can be used. Select the specic
volume you want to address by pressing:
4 DISC 5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SET UP DISC
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
DISC VOLUME , then enter the desired volume number and press 4 x1 5 .
V olume 0 through 7 may be specied. F actory Preset selects volume 0.
Note
Y ou must initialize each hard disc volume before use . Refer to \Initializing a
Hard Disc" later in this section.
If the disc drive does not respond to subsequent commands the message NO DISC is displayed.
Check the disc address again (both on the unit itself and in the receiver's 4 LOCAL 5 Menu), Also
check and the unit and volume number again.
Initializing a Hard Disc
If using a hard disc for the rst time you must initialize each volume . Y ou can do this using a
computer , or using the HP 8530A. T o initialize the hard disc using the HP 8530A, follow these
steps:
1.
Set the volume number to 0 by pressing: 4 DISC 5
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
SET UP DISC
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
DISC VOLUME 4 0 5 4 x1 5 .
2.
Press:
N NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
INITIALIZE LIF DISC
3.
Press
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
INIT LIF? YES . Depending on the size of that volume it will take between 10 to 30
minutes to initialize .
4. Select the next volume number (if using a multi-volume drive), repeat steps 1, 2, and 3.
5. Repeat the above steps for each volume .
Disc Drive Operation 15-9