horiba SF-1U, Инструкция по эксплуатации

Страница: 57 / 60

E-IV
②
When the automatic wetting operation in response to R commands is completed
normally:
Format Delimiter Response data desription
"STBY" <CR> When completing automatic wetting operation.
③
If the equipment has initiated a normal measurement, automatic wetting operation
when it receives an R, S or P command:
The equipment ignores the command received and returns the state of present
measurement operation.
Format Delimiter Response data desription
"S1" <CR> In process of normal measurement event.
"S2" <CR> In two times automatic measurement or in process of measurement
operation
"S3" <CR> In three times automatic measurement or in process of measurement
operation
⋮
⋮
⋮
⋮
⋮
⋮
"S10" <CR> In ten times automatic measurement or in process of measurement
operation
"R" <CR> In process of automatic wetting operation.
Data format above:
Depending on whether in the normal measurement event, automatic measurement event or
automatic wetting operation, the equipment selects from above and returns the data.
④
When an E command stops the equipment or error occurs during normal measurement
automatic measurement or automatic wetting operation:
The equipment returns the state of aborting the present operation, present parameter
settings and alarm condition.
Order Format Delimiter Response data description
1 "STP1" <CR> When aborting measurement operation.
2
"ST.T_25.0" <CR> Calibration temperature
※
”_” indicates blank. "ST.T__0.0" <CR>
3
"MJ.T_25.4" <CR> Measured temperature
※
”_” indicates blank. "MJ.T__9.4" <CR>
4
"AT.P1070.0" <CR> Set atmospheric pressure
※
”_” indicates blank. "AT.P_730.0" <CR>
5
"A0" <CR> When no error occurs.
"A1" <CR> When start detector detection error occurs.
"A2" <CR> When slop detector detection error occurs.
"A3" <CR> When detector luminous energy upper limit error occurs.
Data formats 2, 3, 4 and 5 above:
2 Depending on whether the calibration temperature is 10.0
℃
or greater or less than 10.0
℃
,
the equipment selects from 2 and returns the data.
3 Depending on whether the measured temperature is 10.0
℃
or greater or less than 10.0
℃
,
the equipment selects from 3 and returns the data.
4 Depending on whether the set atmospheric pressure is 1000.0 hPa or greater or less than
1000.0 hPa, the equipment selects from 4 and returns the data.
5 If operating normally, the equipment selects “A0”. If an error occurs, the equipment selects
“A1”,”A2” or “A3” depending on the type of the error and returns the data.