horiba SF-1U, Инструкция по эксплуатации

Страница: 42 / 60

E-7
6.1.3. Installing measuring unit
①
Install the measuring unit (VP-1U-VP-4U) suitable for the intended flow rate
measurement as follows. Align hook pin on the equipment with the groove on the
measuring unit to insert.
②
Turn the fixing lever to the direction arrow in Fig.3 to complete the installation.
※
when you uninstall the measuring unit, turn the fixing lever to the original position.
Then pull up the measuring unit gently while holding the SF main body.
CAUTION
BE SURE TO FIX MEASURING UNIT.
Make sure that the measuring unit is fixed to the main body by turning the
fixing lever when you install. Carrying or using them without fixing may cause
damage or injury through dropping or turning over
Fig.3 Installing measuring unit Fig.4 Pouring filming liquid
6.1.4. Pouring filming liquid
Put the nozzle of filming liquid bottle, 2 cm to 3 cm, into the measurement gas inlet port on the
left side of the measuring unit. Fill the equipment with filming liquid gradually up to the
liquid level, between 2 blue lines on the liquid level window. Be sure not to create bubbles.
NOTE

Do not put the nozzle more than 4 cm into the measuring unit. It will be
cause of a trouble.

Be sure to use the designated filming liquid Snoop
®
. Use of other soap
water not only causes inadequate filming but contaminates the measuring
unit and deteriorates the packing.

Be sure the liquid level is always between two blue lines when you
measure. The liquid level above or below the upper and lower levels
adversely affect the film creation and measurement accuracy.
①
②
Groove
Hook pin
Filming
liquid
Snoop
®
Connector