Honeywell Thor VM3, Руководство пользователя, Страница: 85 / 378

Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide 73
Connect Cables
There are many cables available for the Thor VM3 including power cables, and data/
communication cables.
Strain Relief Cable Clamps
Equipment Required: Phillips screwdriver (not supplied by Honeywell)
There are five strain relief cable clamps secured to the Standard Dock.
There is one strain relief cable clamp and three strain relief brackets for securing cables
to the Enhanced Dock.
Use the strain relief clamps to secure audio, power, and I/O cables attached to the Thor
VM3 dock.
Use the left-most strain relief clamp for the power cable.
To use the strain relief clamp(s):
1. Determine the proper strain relief cable clamp. There are three sizes of cable clamps
on the Standard Dock which should be matched to the cable to be secured. For
example, the largest clamp (on the left when viewing the back of the dock) is
designed to secure the power cable. For the Enhanced Dock there is a single cable
clamp. Use this clamp for the power cable, Use the brackets for all other cables.
2. Remove the strain relief clamp from the Thor VM3 by turning the screw
counterclockwise. Put the screw aside in a safe location.
3. Slide the strain relief clamp over the cable.
4. Using a Phillips screwdriver and the screw that was removed, refasten the clamp
holding the cable to the Dock. Do not stretch the cable. Leave enough slack in the
cable to allow it to be connected and disconnected easily when needed.
5. Continue in this manner until all cables are secured to the dock.
To use the strain relief brackets (Enhanced Dock only):
Standard Dock Enhanced Dock