Hofmann geodyna 8200, Руководство оператора

Страница: 180 / 184

180
....... ........
ii-1
ii-2
Installation
ii Transport, unpacking and contents
Carriage instructions
The wheel balancer is supplied on a pallet.
• Use a pallet truck (
Figure ii-1
) to bring the unit to
its working area.
Unpacking
WARNING: PREVENT THE STRAPS FROM
SPRINGING LOOSE AFTER BEING CUT.
• Cut the straps.
• Open the top of the box.
• Remove staples from the bottom of the box. Lift the
box up and over the unit.
• Carefully unwrap the balancer and spare parts
supplied.
• Check the contents of the shipment.
Contents
The shipment contains:
- a wheel balancer.
- a Declaration of Conformity (EC).
- the accessories mentioned in Section 3.1 of the
Operator’s Manual.
- 3 threaded pins with accessory support plate.
- a power cable.
- a wheel guard (if present).
Tools required
- screwdriver / bar (diameter 4.5-5 mm)
- wrenches: 13 mm, 17 mm
- Allen wrench: 5 mm
Positioning
• Remove the bolts that secure the wheel balancer
on the pallet.
WARNING:
DO NOT LIFT OR MOVE THE WHEEL
BALANCER BY THE MAIN SHAFT OR
MEASURING UNIT
.
• Refer to
Figure ii-2
. Move the wheel balancer from
the pallet to its working location.
Note:
To handle the unit, preferably use the
accessory support pins (mount as
instructed in section iii) and/or the wheel
guard shaft (if any).
....... ........