Hofmann geodyna 8200, Руководство оператора

Страница: 94 / 184

94
....... ............... ........
5-48
4-11
4-12
3
4
Operation “ MANUAL MODE ”
5.14.1 Saving a Wheel Profile
Up to 9 wheel profiles can be saved.

Clamp the wheel you wish to save the profile of.

Set and acquire all the wheel data, including the
number of spokes if an Alu P is required.

In the RIM DATA ENTRY screen press the
“SPECIAL” key (
Fig. 5-48
).
The WHEEL PROFILES screen is displayed (
Fig.
4-11
).
The current wheel profile data are highlighted in a line
on its own at the bottom of the page.

In the 9 position list, use the Scroll command to
choose the current profile registration position.

Press key (
3, Fig. 4-11
) to save data.
The data are now saved permanently in the chosen
position and can be recalled when required.
Note
: If the profile is overwritten with other data it is
no longer shown in the list.
5.14.2 Recalling a Wheel Profile from the
memory

Clamp the wheel to the balancer.

In the RIM DATA ENTRY screen press the
“SPECIAL” key ( Fig. 5-48 ).
The WHEEL PROFILES screen is displayed (
Fig.
4-11
).

Type on one of the nine lines to select the profile
indicated for the wheel being processed.

Press key (
4, Fig. 4-11
) to apply the selection.
The RIM DATA ENTRY screen will open (
Fig. 4-12
)
and show the data recalled.

Check that the settings in the Indications Field and
Status Bar panel are correct.
The machine is now ready to proceed with the
measuring run (

5.13).
....... ........