Hitachi SJ Series, Руководство пользователя

Страница: 713 / 786

Appendix 1-2
Appendix 1 List of Parameters

About monitor mode

About parameter mode
• The voltage class is shown by 200V/400V.
• See "Chapter 20 Specifications" for the product
model.
The description applies to all models unless
otherwise specified.

Notes on setting parameters
•
When setting parameters, we expect you to
fully understand various points to be noted.
•
Make sure to check and set the following
parameters to protect the motor.
- [Hb102]-[Hb108] (for IM)
- [Hd102]-[Hd108] (for SM/PMM)
- [bC110] (electronic thermal level)
→ for motor overload protection current
- [bb160] (overcurrent level)
* When setting the thermal subtraction
characteristics, set a value in accordance with
the characteristics of motor. Otherwise, the
motor may be burned.
• If the initial value differs depending on the
destination, symbols (JPN)/(EU
・
ASIA)/(USA)/
(CHN) are separately described.
If there is no description, the initial value is the
same for all destinations.
• Models correspond with the following destinations.
P1-*****-*FF (*FF):(JPN)
P1-*****-*FEF (*FEF):(EU, ASIA)
P1-*****-*FUF (*FUF):(USA)
P1-*****-*FCF (*FCF):(CHN)
* Parameters other than those changeable during
operation can be changed only when the device is
stopped. The user can change the parameter that
cannot be changed during operation after the
device decelerates and stops and output is
stopped. However, it cannot be changed if the
soft-lock function is activated.
• The text includes notes with a symbol “*)”.
After configuring settings for motor protection, choose
the frequency command destination and operation
command destination to run the device.
• With [AA101], choose a frequency command
destination.
• With [AA111], choose an operation command
destination.
• With [FA-01], check that the frequency command is
received.
*) To run the inverter, a frequency command and
operation command are required. If commands
are sent using V/f control, there is no output if the
frequency command is 0Hz.
Code Name Data range Page
XX-01 Monitor name Data Range Reference page
Code Name Data range Initial value Note Page
YY101 Parameter name Data range
ZZ (*FF)/
UU (*FEF)
(*FUF)
(*FCF) (Write down
the setting
value)
Reference page
YY-02 Parameter name
(200V class) data range
(400V class) data range (200V class) VV
(400V class) WW
(Write down
the setting
value)
Reference page
Do
Codes that can be changed
during operation are underlined.