Hitachi SJ Series, Руководство пользователя

Страница: 384 / 786

12-17-23
Chapter 12 Inverter Functions
Parameters
• Do not set the orientation speed to a high
frequency because the deceleration behavior
becomes the positioning status within two rotations.
The overvoltage protection may cause a trip.
• Set the orientation stop position by dividing one
rotation to 4095 (0 to 4095) in the forward rotation
direction starting the reference point. (4096 division
regardless of the number of pulses for the
encoder.)
The reference point is where the pulse is input
between EZP-EZN and the stop target position is
located in a layout shown in the diagram to the left
from the viewpoint of the motor axis load. (For a
positive phase connection)
Item Function Code Data/Data Range Description
Control Method [AA121] 10 Vector control with sensor
Vector control mode selection [AA123]
00
Speed/Torque control
mode
01
Pulse train position control
mode
Pulse train input (internal)
Detection target selection
[CA-90]
00 PCNT function
01
Pulse train frequency
command
02 Speed feedback
03 Pulse count
Encoder constant setting
(main body)
[CA-81] 32~65535
Setting of the number of
pulses.
Encoder phase sequence
setting (main body)
[CA-82]
00 A phase precedes
01 B phase precedes
Encoder constant setting
(P1-FB)
[ob-01] 32~65535
Setting of the number of
pulses.
Encoder phase sequence
setting (P1-FB)
[ob-02]
00 A phase precedes
01 B phase precedes
Orientation
Stop position input destination
selection
[AE-10]
00 Parameter setting
01 Option 1
02 Option 2
03 Option 3
Orientation stop position [AE-11] 0~4095 Note 2)
Orientation speed setting [AE-12] 0.00~120.00(Hz) Note 1)
Orientation direction setting [AE-13]
00 Forward rotation side
01 Reverse rotation side
Positioning completion range
setting
[AE-04] 0~10000(pls)
Set the value equivalent to
encoder 4 multiplication
Positioning completion delay
time
[AE-05] 0.00~10.00(s)
Set the time from the
positioning completion to
the output of the [POK]
signal.
Position control feed forward [AE-06] 0~655.35
Position feed forward gain.
Position loop gain [AE-07] 0.00~100.00(rad/s) Position loop gain.
Input terminal [CA-01]~[CA-11]
069 ORT: Orientation
109 PLZ: Pulse train input Z
Output terminal [CC-01]~[CA-06]
043
POK: Positioning
completion
Relay output terminal [CA-07]
!
Position of the Z
pulse
Reference point
0
1024
3072
2048
When looking at the
motor shaft from the
motor axis load