Hitachi S10VE, Руководство пользователя

Страница: 162 / 506

8. Tools
8-33
(3) To set network information, enter the information for the selected network and then click Set .
The information entered in the Set Network window when you click the Set button takes effect when
you click the Write PCs button.
- Select Network
Select the type of network you want to configure.
Item Description
Ethernet 1 Settings for CPU module built-in Ethernet port ET1
Ethernet 2 Settings for CPU module built-in Ethernet port ET2
- ST Number , IP Address , Sub Net Mask , and Broadcast Address
Set the station number, IP address, subnet mask, and broadcast address of the network selected in
Select Network . As the station numbers of Ethernet 1 and Ethernet 2, set the same setting as the ET
ST.No. switch of the CPU module.
If you enter a different station number and click Set , a message appears asking you to confirm the
overwriting of the station number of the other Ethernet station.
Figure 8-31 Message asking for confirmation of Ethernet station number overwrite
Note: If you overwrite the station number for Ethernet 2, the message Station number of
Ethernet2 is overwritten. Is it OK?
appears.
Click Yes to apply the settings including the new station number.
To cancel the settings, click No .
- Setting Routes Num , Network Address , and Gateway IP Address
To configure the routing table, set the number of routes and the network address and gateway IP
address of each route.
You can set a maximum of nine routes in total across Ethernet 1 and Ethernet 2.