HIKVISION DS-K1T605 Series, Руководство пользователя

Страница: 75 / 107

7. Enter the port number for the protocol.
Note
The port number of the wireless network and wired network
should be consistent with the port number of EHome.
8. Select the Protocol Type as EHome.
9. Set an account name for the network center.
10. Click Save.
Create EHome Account in Wireless Communication Mode
You can set the account for EHome protocol in wireless
communication mode. Then you can add devices via EHome
protocol.
Steps
Note
This function should be supported by the device
1. Enter the Access Control module.
2. On the navigation bar on the left, enter Advanced Function
More Parameters .
3. Select an access control device in the device list and enter
Network Wireless Communication Center .
4. Select the APN Name as CMNET or UNINET.
5. Enter the SIM Card No.
6. Select the center group from the drop-down list.
7. Enter the IP address and port number.
Note
• By default, the port number for EHome is 7660.
• The port number of the wireless network and wired network
should be consistent with the port number of EHome.
8. Select the Protocol Type as EHome.
9. Set an account name for the network center.
10. Click Save.
Set Device Capture Parameters
You can configure the capture parameters of the access control
device, including manual capture and event triggered capture.
Note
• The capture function should be supported by the device.
• Before setting the capture parameters, you should set the
picture storage first to define where the event triggered
pictures are saved. For details, refer to .
Set Triggered Capture Parameters
When an event occurs, the camera of the access control device
can be triggered to capture picture(s) to record what happens
when the event occurs. You can view the captured pictures when
checking the event details in Event Center. Before that, you need
to set the parameters for the capture such as number of pictures
captured for one time.
66