Harris eCDi, Техническое руководство

Страница: 73 / 190

1/3/05 888-2517-001 3-9
WARNING: Disconnect primary power prior to servicing.
Section 3 Operation
eCDi ™
To edit a meter reading, first select the meter in the pull-down menu labeled “Select”.
This has the same meters as the list in Figure 3-6. Once the desired meter is selected, the
following fields must be set to the desired value: (an example is given in Figure 3-7).
Figure 3-7 Editing Meter Log Settings
a.
Click the “Log” checkbox to enable the meter for logging. Whenever a meter is
selected the box will be un-checked. This box must be checked every time a
meter is edited or it will be removed from the available list in the Meter Log.
b.
Select the desired interval. The choices are shown in Figure 3-7.
c.
Set the Lo and Hi limit for the graph in the Meter Log. This function allows you
to zoom in on a graph to see smaller variations or zoom out to see the entire pos-
sible swing. These settings do not affect the actual meter readings, only the limits
on the graph. These values must be entered even if you are not changing them.
Use the meter list above to see the previous values.
d.
Use the “Change Unit:” pull-down list to select the unit of measure or leave it at
UNCH(anged).
e.
Clicking the Default checkbox and pressing Submit disables all meters (remov-
ing them from the Meter Log) and resets all other settings to the factory defaults.
When you are finished, press the Submit button at the bottom of the screen, then press
the Back button to get to the Configuration Main Menu and then press the Apply
button.
To see any changes go to the Meter Log in the Browser Menu, select the desired meter
from the pull-down list and press
Submit. The graph should now match your new
settings. The graph will plot out all recorded readings for that meter with the X axis
being time and the Y axis the Lo and Hi limits set in the Configuration screen.