Harris eCDi, Техническое руководство

Страница: 54 / 190

2-32 888-2517-001 1/3/05
WARNING: Disconnect primary power prior to servicing.
eCDi ™
Section 2 Installation & Setup
STEP 11
Select Feature Key on the main menu to get the screen shown in Figure
2-23. The Feature key number is normally entered at the factory before
shipment, but is also recorded in the Factory Test Data included with the
unit. If not already entered, type in the 40 character key to setup the
eCDi™ for the correct hardware and features.
STEP 12
Once the key is entered, click on Submit and then verify that the correct
hardware and features are displayed. Depending on the transmitter type
(chosen by the feature key) you may also need to select the correct type
of exciter for each exciter position. If you change the exciter selection,
click on Submit to finish the Feature Key configuration.
INFO:
?
The Feature Key is an encrypted code word that contains all of the hardware
configuration, such as transmitter type and any add on features such as
Performance Monitoring. The Feature Key is coded to the hardware in the
eCDi™ and therefore can only be used on a specific eCDi™ unit.
NOTE:
Other than the exciter selections, the text boxes below the Feature Key box are
not editable and can only be changed with a different Feature Key. If the
transmitter hardware or features purchased do not match the information
displayed, contact technical support.
Figure 2-23 Feature Key Configuration Screen
STEP 13
Once the information is entered, submitted and verified, press Back to
return to the main menu. Click on User mgmt to access the User
Management screen in Figure 2-24.
an example. Do not
use this for your
installation.
This screen is only
NOTE:
These features are chosen
by the Feature Key and
connot be changed without
changing the Key
The exciter type
must be chosen on
site depending on
the equipment
present. If no
exciter is to be
controlled, then
select None/Other.