Harris eCDi, Техническое руководство

Страница: 59 / 190

1/3/05 888-2517-001 2-37
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation & Setup
eCDi ™
STEP 27
This screen is for setting up Email addresses that will be alerted when
there is a fault condition in the transmitter. To add an address, simply
type the address in the “Add address” text box and click on Submit. The
address should then show up in the Address List. The Delete address
pull down menu can then be used to delete any entered addresses.
NOTE:
If an address is entered incorrectly simply delete it and add it again.
STEP 28
The station Network Administrator should be able to supply the SMTP
Server IP and the eCDi email address. The email address is used as the
sender address, so recipients know from where the email was sent.
STEP 29
If your mail server requires authentication then check the “Requires
Auth” checkbox and enter a User Name and Password for each address.
Figure 2-28 Email Configuration Screen
STEP 30
Set Email Filters. Email filters provide a way to block or limit the alert
emails being sent. Figure 2-29 shows the choices for the 3 categories of
email filters:
a.
Faults
b.
Warnings
c.
Info