Harris eCDi, Техническое руководство

Страница: 145 / 190

1/3/05 888-2517-001 C-1
WARNING: Disconnect primary power prior to servicing.
eCDi ™
Appendix C
Atlas Fault and
Meter Log Reference
C.1 Introduction
For the AtlasCD transmitter, all data in the transmitter is either displayed via the GUI,
lights an LED or is sent to the parallel remote control ports. Some of the fault reporting
is done in the form of highlighting a button red, such as most summary faults, but this
fault will not usually show in a fault log on the transmitter GUI. However, when the
data is sent out a serial port to a device such as the eCDi™ the only way to represent a
fault is through a name. The same issue applies to Metering data. Therefore, this section
is divided into 2 parts:
•
Fault Log Reference
•
Metering Log Reference
The Fault Log Reference is a group of tables that list all of the faults that can be
reported and logged on the eCDi™ for a Atlas transmitter. The faults are divided into 5
tables by category:
•
Table C-1, “Atlas System Faults,” on page C-2
•
Table C-2, “Atlas Power Supply Faults,” on page C-3
•
Table C-3, “Atlas PA Faults,” on page C-4
•
Table C-4, “Atlas Output Faults,” on page C-6
•
Table C-5, “Atlas RF Drive Faults,” on page C-6
The Metering Log Reference is a table that lists all of the Meter readings that can be
logged on the eCDi™ for a Atlas transmitter:
•
Table C-6, “Atlas Meter Log Readings,” on page C-7