Harris ATLAS ANALOGUE, Руководство пользователя

Страница: 55 / 134

7/26/05 888-2523-001 2-25
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation / Initial Turn-On
ATLAS Analogue
of a trisodium phosphate-based detergent, such as Cascade, in 2 gallons of water),
proceed with the following steps.
Strain mixture into tank through a fine filter.
Run the system for 1 hour. Alternate pumps A and B for 30 minutes each.
Drain the system.
NOTE:
Pump Module drain valve barbs can be fitted with 1/2" ID hose.
To drain the system open all of the system and cabinet drain valves. Once draining is
complete close all cabinet drain valves
2.11.3 Initial System Flushing
Flush system of cleaning solution. Before the initial transmitter operation the cooling
system must be purged of most of the cleaning solution residue left from the cleaning of
the system.
The flushing can be accomplished by alternately filling, running and draining the
system, two to four (or more if needed) times using water.
NOTE:
The length of flushing time, and number of fill/drain cycles needed to achieve
desired water quality will vary with system size. The smaller the system, the
shorter length and lesser number of fill/drain cycles. The opposite will be true for
larger systems.
Fill system with water (see section B.1 Coolant and Water Recommendations in
Appendix B).
Run system for approximately 20 minutes. Alternate pumps A and B for 10 minutes
each.
Drain system.
Repeat above steps. EXCEPT - During the last flushing with water cycle, the cabinet
(PA and chiller plates) and test load connections will be opened to the cooling system.
Perform the following three steps prior to the last fill, run, and drain cycle.
•
Open cabinet (all cabinets if multi-cabinet Atlas) supply and return line valves.