10
3-1-3. External Hard Drive Setup
It is possible to expand CDR-16T recording capacity by adding additional external hard
drives. Multiple external hard drives can be connected via the rear panel SCSI connector.
Connection is as illustrated below.
Important
It is possible to expand CDR-16T record capacity by
configuring up to 9 hard drives. Total array is limited to 9
drives, one internal drive + 8 external drives.
Set SCSI ID
The CDR-16T series internal HDD must be assigned SCSI ID number #0
. Each
connected external hard drive must be assigned a different SCSI ID number other than #0
(no repeat numbers). Consult drive manual for ID setting procedure at drive unit. If ID settings
are wrong, operations cannot be properly performed.
Termination Connector
The last external HDD in the CDR-16T array must be terminated with the supplied accessory
SCSI termination connector. If last drive is not terminated, operational problems could result.
T4 .0 A
S CS I 6 8 p i n (Am p h e n o l )
F
U S
E
P US H
SER.No.
1 3
1 2
1 6
1 5
3
6
1 0
7
8
9
1 1
1 4
2
1
C AM ERA
O UT
A UTO
IN
M ON IT OR O UT
IN
R S-2 32 C
O U T
AUD IO
L
R
SCSI- A
R EMO T E
ALARM
Y/C
1
2
4
5
75Ω
A C1 0 0 - 2 4 0 V - 5 0 /6 0 H z IN
External
hard disk
drive #1
External
hard disk
drive #2
Up to
external
hard disk
drive #8
Termination
connector
Required at last external HDD in
array. (Supplied as accessory)
