135
10. If Problems Occur
If any of the following problems occur during operation of your CDR-16Tunit, proceed as indicated
below to see if problem can be corrected before assuming a unit malfunction has occurred.
Problem
Check
CDR-16Ts cannot be controlled while data is loading. Verify
data load is complete. Data load completion time determined
by size and number of drives configured.
See sec. ‘4-1. Power ON / OFF’.
Cannot control CDR-16T
Verify KEY PROTECT (button lock function) is set to OFF.
Other settings will lock out front panel button controls.
See sec. ‘6-1. Protect’.
Verify cameras are connected at rear panel.
Verify cameras are assigned for recording in menus.
See sec. ‘6-3-4. Regarding Record Channel Setting’.
Verify hard disk has been properly formatted.
See sec. ‘6-10. HDD’.
Cannot record
Verify hard disk has been assigned as PB/REC USE in
menus.
See sec. ‘6-10-1. Assign HDD Use’.
Verify hard drive material has been recorded to the area being
played back.
Cannot playback
Verify hard disk has been assigned as PB USE ONLY or
PB/REC USE in menus.
See sec. ‘6-10-1. Assign HDD Use’.
Verify program times have been set in RECORD menu.
See sec. ‘6-4. Timer Program’.
Auto record function does
not start
Verify REC PROGRAM has been set to TIMER in FUNCTION
menu.
See sec. ‘7. Function Menu’.
(Continued following page.)
