Furuno FA-150, Руководство по установке

Страница: 89 / 216

U
lstein Power & Control AS
This document and its content is the property of ULSTEIN. Non-
public information contained herein shall be treated as
Confidential Information. No use, copying, citation or publication
of this document or its content is permitted without prior written
consent from ULSTEIN. Any conflicts arising from unauthorized
use shall be governed by the laws of Norway.
File Name:
BRI-D32004-01II (D)
System Installation
Manual.doc Page:
Page 17 of
56
3.2.2. Overview terminal pin assignment at the terminal strip (Inside box)
Figure 3: Overview terminal pin assignment at the terminal strip
Table 3: Overview of terminal pin assignment
6 Power requirement 12 – 24 V DC(Direct current) plus und mass
7 8X RS422
TX+ RX+
TX- RX-
8 2X RS232
IN = Input
A B
OUT = Output
A B
Every output can be used with up to 10 listeners.
2X RS232
TX= Output to another device (Max. 2,5mm
2
)
RX= Input from another device (Max. 2,5mm
2
)
GND= Ground of the serial interface (min. 2,5mm
2
)
Attention: Ground for CH0 is the Ground form COM0(Pin GND0)
Ground for CH1 is the Ground form COM0(Pin GND1)
9 Canbus
Without figure: 3V battery for the internal power supply of the real time clock (CR2032
1X m box magic plex8 GIC Pro and 1Xin the monitor)
3.2.3. Earthing of the box
Grounding:
Length of the cable max.50cm. Cross section:
6mm
2
. Earthing resistance <0,1Ohm
NOTE: Must not be assigned to other earthings.