Furuno FA-150, Руководство по установке

Страница: 126 / 216

U
lstein Power & Control AS
This document and its content is the property of ULSTEIN. Non-
public information contained herein shall be treated as
Confidential Information. No use, copying, citation or publication
of this document or its content is permitted without prior written
consent from ULSTEIN. Any conflicts arising from unauthorized
use shall be governed by the laws of Norway.
File Name:
BRI-D32004-01II (D)
System Installation
Manual.doc Page:
Page 54 of
56
XI. Press the [ ] or [ ] arrow to increase or decrease the COM port number by one.
Adjust the COM port previously identified in the Device Manager (in this
example "COM27") in the Communication Parameters accordingly. You can
leave all other parameters (Baudrate, Parity, Stop bits, Motorola byteorder, Flow
Control) and the gateway settings as they are.
XII. Click
[OK]
to confirm your entries.
2.2.5.3. Loading and Starting the Program
I. To load the program into your PLC, click on the
Login
menu item in the WAGO-
I/O- PRO dialog under the Online menu.
II. Then start program execution in the PLC via the menu item Online > Start .
III. Now select the menu item Online > Create bootproject to create a boot project.
With this boot project, the program is automatically loaded when restarting the
PLC.
IV. To automatically start the PLC after restarting, move the Operating mode switch
behind the cover cap of the service interface to the top position (RUN) on the
PLC.
Figure 28: Operating mode switch at the top position (RUN)