Furuno FA-150, Руководство по установке

Страница: 104 / 216

U
lstein Power & Control AS
This document and its content is the property of ULSTEIN. Non-
public information contained herein shall be treated as
Confidential Information. No use, copying, citation or publication
of this document or its content is permitted without prior written
consent from ULSTEIN. Any conflicts arising from unauthorized
use shall be governed by the laws of Norway.
File Name:
BRI-D32004-01II (D)
System Installation
Manual.doc Page:
Page 32 of
56
3.4.11. Network port configuration
Figure 19: Network port configuration
1
"On/Off"
As for the other ports, you can choose to enable or disable the network port. By leaving this
checkbox unchecked, no network port will be activated and all other parameters on this
screen will be ignored.
2
"Protocol"
Here you can choose what kind of protocol you want to use for the port, between UDP,
Multicast and TCP.
3
"Type"
Here you can choose what type of port it will be, between Reader, Writer and Server. Note
that, if you chose the UDP protocol, you can not choose the Server type.
4
"Broadcast"
Only usable if you chose UDP Reader or UDP Writer. Check it if you want to use a
broadcast address.
5
"Set Dest from Header"
Only usable if you chose Reader or Server. Checking it will disable and ignore the field 10.
If checked, incoming NMEA sentences having a TCP header containing the field d:A/ias
(e.g. "\d:GPS2,c:16857 4.31 *A3") will then be rerouted to the port having the alias Alias
(here GPS2).
6
"Convert to Ethernet-Protocol"
If checked, all outputs will be prefixed by an Ethernet header of the form \s:Aiias,c:16857
4.31 *A3, containing the Alias of the port and a timestamp