Furuno FA-150, Руководство по установке

Страница: 97 / 216

U
lstein Power & Control AS
This document and its content is the property of ULSTEIN. Non-
public information contained herein shall be treated as
Confidential Information. No use, copying, citation or publication
of this document or its content is permitted without prior written
consent from ULSTEIN. Any conflicts arising from unauthorized
use shall be governed by the laws of Norway.
File Name:
BRI-D32004-01II (D)
System Installation
Manual.doc Page:
Page 25 of
56
3.4.6. After configuration
If this controls succeed, clicking "Change network configuration" will send a message to the
multiplexer to make it update its configuration. The multiplexer should normally send a reply
and reboot.
Figure 10: Network configuration
NOTE: As the system uses here multicast, it can happen that the multiplexer does not reply.
After a few seconds, you should see this window instead.
Figure 11: Network configuration
This does not mean that the modifications were not taken into account, so it is here
recommended to restart the configuration software to list the devices on the network again.
If the multiplexer correctly replied, then, after approximately 30-40 seconds, you should get a
message indicated that the device has restarted.
Figure 12: Network configuration