31
TESTS AND ADJUSTMENTS
It is important that your laser is tested and adjusted (if needed) for proper use before you start your
first job. The following will be on our list of tests and adjustments:
1. Focus Lens Adjustment
2. Laser Tube Test
3. Mirror Alignment
4. Focusing
5. Laser Head Adjustment
6. Belt Tension
Focus Lens Adjustment
The focus lens assembly is preinstalled at the factory, however it can sometimes become loose or
out of adjustment during the shipping process.
FOCUS LENS ADJUSTMENT STEPS:
1. Adjust Focus Lens.
The Focus Lens attaches to the focus head using one (1) M3
thumbscrew and two (2) M3 spring washers (G). Be sure all screws and washers are
accounted for and properly placed and tightened (Figure 1).
2. Check the Air Assist.
Be sure the air assist tube is attached to the pushtoconnect
connector once the head has been secured (Figure 2).
3. Check for Interference
. Run a job with the laser OFF to verify the air tube will not interfere
with the beam path or rub against the X rail while engraving. Alternatively, this can be done
manually by physically moving the laser head with your hand in a rectangular pattern within
Technical Support is available from 8:00 am (PST) to 5:00 pm (PST) Monday through Friday at
.
