14
Unboxing Your HSeries Hobby Laser
When your HSeries (5th Gen) Hobby Laser arrives, it will require careful unboxing and
examination of parts. Follow these instructions for best results.
FRAGILE PARTS! Be gentle in removing the foam packaging and
accessories. Never pull or force the packaging loose from the laser
cutter. Be particularly aware that the water inlet and outlet nodes
protrude from the tube and are extremely fragile when unboxing your
laser tube.
UNBOXING STEPS
1.
Create a work space.
You will need an open, level work space to place your laser cutter. A
solid table with adequate room (the machine’s dimensions are 32” x 20” x 8.25”) for the
machine is recommended. Be sure the workspace is free of fire hazards and is well
ventilated. Always have a fire extinguisher handy in case of emergency.
2. Carefully open the top of the box.
Set the box on a flat space near where you will place
the machine. Open the box carefully from the top. If you use a cutting tool to open the box,
be careful not to allow the cutting edge to touch the machine or any packed accessories.
Always use all tools with caution and only as specified by the manufacturer.
3. Remove “honeycomb” cutting table.
Remove the honeycomb plate (B) from the box and
then remove the bubble wrap surrounding it. Set the honeycomb plate aside for now. Once
we have removed the packed accessories we will insert it into the base of the machine.
4. Remove the Machine from the box.
With the foam packaging intact, gently lift the
machine out of the box and place on a clean flat surface such as the table you plan on
keeping it. Be aware that the machine weighs 55 lbs. Find someone to help you lift it if this
is a strain for you. Next slide off the foam packaging. The machine should now be flat on
your work surface.
5. Remove protective sheet from lid.
With the foam supports and the honeycomb removed,
you will now see the lid of the laser cutter. To protect the lid during shipping there is a
protective film material covering it. Carefully peel off this film from the plexiglass lid and
dispose it in a proper waste container.
6. Remove Accessories.
Nestled in packing foam, inside the interior of the machine, are the
following parts and accessories: a plastic bag with cords and small accessories, the water
pump and perhaps the air compressor (sold separately). Inspect these parts to insure they
are accounted for and intact.
Technical Support is available from 8:00 am (PST) to 5:00 pm (PST) Monday through Friday at
.
