Fuji Xerox Document Centre C250, Руководство пользователя

Страница: 56 / 556

3 Copy
54
Copy
3
„
Auto (Copy All)
The height and width ratios are set automatically to match the paper size and the
document is copied at a slightly reduced size to prevent image loss at the edge of the
original. If this option is selected, a check mark is added.
„
X (width) Y (height)
Set the height and width ratios within the range from 25 to 400% in 1% increments.
„
XY
You can simultaneously change the numerical values of the height and width by the
same amount.
When [Calculator %] is Selected
You can specify a different size for the height and width.
If you specify both the original document size and the copy size, the copy ratios for the
height and width are calculated automatically according to the sizes that you entered.
The calculation results are indicated by copy ratios within the range from 25 to 400%.
1
Select [Calculator %].
2
Enter the value for the original
document width in [Original Size] of
[X] (width) using the numeric
keypad, and select [Next].
3
Enter the value for the copy size
width in [Copy Size] of [X] (width)
using the numeric keypad, and
select [Next].
4
In the same way, enter the original document height value and copy size height value
in the [Original Size] and [Copy Size] of [Y] (height), and select [Next].
Note • To change the copy ratios you have entered, select [Next], move [ ], and enter the
numerical values again.
„
X (width) Y (height)
The automatically calculated ratio is displayed depending on the values entered in
[Original Size] and [Copy Size].
„
Original Size
Set the height and width of the original document size from 1 to 999 mm in 1 mm
increments.
„
Copy Size
Set the height and width of the copy size from 1 to 999 mm in 1 mm increments.