Fuji Xerox Document Centre C250, Руководство пользователя

Страница: 338 / 556

11 Setups
336
Setu
ps
11
Communication Mode
Set the communications mode. You can select from [G3 (Auto)] or [F4800].
When the destination is specified by an address book entry with the communications
mode set, it is not possible to change the communications mode in the [Fax/iFax]
screen.
Note • When the iFax kit is installed, you can select [G4 (Auto)].
• For iFax, the setting applies to the section between the fax gateway and the recipient fax.
Resolution
Set the image quality in a transmission.
Select from [Panel] (image quality selected on the control panel), [Standard], [Fine],
[Superfine (400 dpi)], and [Superfine (600 dpi)].
Cover Note
Select whether to send transmissions with a cover sheet attached. If attached, specify
comments relating to the recipients and sender to be included in the cover sheets.
Comments must be registered in advance.
For information about comment registration, refer to "Comments" (P.341).
1
[Off] or [On].
2
When [On] is selected, select
[Comment].
3
Select [Recipient's Comment].
4
Select [On], and select a comment
from the displayed list of
comments.
Note • Select [ ] to display the
previous screen and select
[
] to display the next screen.
5
Select [Save].
6
To insert a [Sender's Comment], repeat the procedure of steps 4 and 5.
Maximum Image Size
Select the maximum storage size from [A3], [B4], and [A4], to match the recipient's
paper size or processable profile.