TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Codice Documento
Rev.
Data di salvataggio
Data di stampa
U500-U600 ISTRUZIONI
02
04/11/2015
04/11/2015
EN
55
GUI DIAGNOSTIC
Upon machine start-up, during the system booting sequence, a diagnostic procedure is performed to check the machine model for which
the Graphic User Interface (GUI) has been programmed (i.e. U500 or U600).
?#""*$#%&;#$%*\%?#!#&<!#$?&['%%?#'&$&<%?&%?%?'@
operating differences.
Therefore, GUI settings are operational only if the GUI application is connected to the machine model it was intended for.
In the event of replacing the control console with a new one or one with a different setup, the technical assistance centre may be authorized
to rest the “machine model” as long as the access code for said operation is known to them (“changeModelPassword”).
The GUI application will start only when the required hardware matches the original setting.
The procedure to follow to resolve an incompatible setting (GUI installed on a U600 machine but set up for a U500 model) is described
below:
1 Hardware check or communication error.
2 Diagnostic page for hardware incompatibility.
3 Enter password to “change machine model”.
4 Machine model selection page.
5 Selected machine model correct diagnostics.
6 Machine OK >> Home page.
U600
U500
