TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Codice Documento
Rev.
Data di salvataggio
Data di stampa
U500 - U600 ISTRUZIONI
02
04/11/2015
04/11/2015
EN
48
Operating pressure regulation
The machine runs at 2 operating pressures:
1. Nailing
pressure:
?%?"<'\%?&#*&&%%&%%?
V-nails in the frame and corresponds to the line pressure. This
pressure is regulated by acting on the main pressure regulator
>%?*%&%#**<&%?<%?""%%#&<%#@#*
of between 5 - 7 bars, depending on the hardness of the wood
being handled.
2. Pressure of the devices designed to block the mouldings:
This is the pressure used by the vertical and horizontal stoppers
during V-nail insertion. This pressure is shown on the pressure
pressure gauge located on the top surface of the machine (A).
3. Select the most suitable pressure values for the materials being
handled: low pressure for soft materials, high pressure for hard
materials (see table B).
B
.
Durezza /
Hardness
Pressione consigliata /
!
"
*$$#$
Soft Clamp
2 bar / 30 psi
Soft Wood
Soft Wood
3 bar / 43 psi
4 bar / 58 psi
Legni Medi / Medio-Duri
A ?CF
5 bar / 72 psi
6 bar / 87 psi
Legni Molto Duri
; %CF
7 bar / 100 psi
8 bar / 115 psi
NOTES
# %>9@9GC>7 &
;,
How to adjust the clamping pressure
1. BY MEANS OF MANUAL REGULATOR:
To alter the operating pressure, proceed as follows (C):
-
Lift the knob by about 3-4mm.
-
Turn it clockwise to increase the pressure, or anticlockwise to reduce the pressure.
-
Press the knob to lock it back in place.
C
A
