TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Codice Documento
Rev.
Data di salvataggio
Data di stampa
U500-U600 ISTRUZIONI
02
04/11/2015
04/11/2015
EN
45
+)&%$#!""%&!(!"!$%%##
$#\%#<%!&%["$<#**>+
1. Position the mouldings on the working bench.
2. Loosen the screw on the bottom of each cylinder using an
appropriate tool (A) and lift/lower the cylinder body to the
required height.
3. If the corner is narrow and you wish to use one cylinder only,
close the handle on the cylinder you wish to block (B). In this
way the stem remains stationary.
4. If the frame is wide, loosen the knob on the cylinder support (C)
and move it so that the stopper is perpendicular to the stapling
point.
CAUTION!
Avoid lifting the stoppers with your hands: after slackening
the two handles, activate the down command of the vertical
blocking device, placing a spacer under the stopper you wish
to lift or inhibit.
Tighten the handles to keep the stoppers still and exclude
self-lifting.
A
B
C
