TRANSLATION OF THE ORIGINAL INSTRUCTIONS (Keep for future reference)
Codice Documento
Rev.
Data di salvataggio
Data di stampa
U500-U600 ISTRUZIONI
02
04/11/2015
04/11/2015
EN
35
The “Auto-placement” system proposes V-nail arrangement and
number depending on moulding dimensions:
=
<&!*<&<!&&[
=
#<<!@"%&[
=
$?#&&#*%\"??%[
=
$?#&##&!&%#&<&!'#$?"%&[
=
*$%%?"<[
=
"%?"<#*#&<#!'*
At the end, it is recommended to protect the program from
'j&%!<$#%&
V-nails auto-placement:
as soon as the New Program has been created, the work page
goes into “auto-placement” mode.
This mode is recognisable as the moulding maximum size and
&#*&<$#%#^#?&
The “Auto-placement” system proposes V-nail arrangement and
number depending on maximum moulding dimensions.
Set the moulding size and determine the head position in line with
the internal edge of the frame corner. To do this, proceed as follows:
1. Move the head by touching the direction arrows until you reach
the desired moulding size.
2. Touch the part that indicates the current head position to set the
new position using the numeric keypad.
As the head moves, the system recalculates the new positions and
V-nail quantities along the assembly line.
The more accurate the size set (or acquired) for the moulding, the
more accurate the proposed positioning of V-nails will be.
The proposed height of the V-nails will be the one used in the last
"#!$?#&%???%[%$?&%?^#?&&#*
at least 2 seconds, then select the new height from the list.
?&>*$%<$*&#*??%[>**"*#$%?^#?&
V-nail symbols.
Press the “ + “ or “ – “ keys to increase or decrease the V-nail
positions.
For each amount set V-nail distance will automatically be evenly
redistributed.
If the amount and type of V-nails is correct, touch the area where
the V-nails are located to memorise their position.
At this point, if necessary, proceed to modify the program by acting
on the single V-nail positions.
NOTES:
& ( !$
!,
