flamco MeiTronic W10, Руководство пользователя

Страница: 47 / 232

47 Service setting manual
EN
Para-
meter
Parameter name Parameter description Setting range Default
setting
S1.6 DIGITAL INPUT
T1, T6, T8
3- Additional direct circuit is
connected. Temp. requirements of
additional direct circuit (P3.5 and
P3.6) are also considered for calcula-
tion of requested boiler temperature.
By schemes with two heat sources
the switchover to other heat source
is done without delay.
4- Switchover from heating to
cooling operation mode.
5- Boost heating function is
activated. This setting disables
regular boost heating function which
is activated by changeover from
night to day temperature period.
6- Liquid fuel boiler is blocked.
Controller will operate only with solid
fuel boiler.
7- Counter for boiler operation time.
0– NO
FUNCTION
1- REMOTE
ACTIV.
2- DIR. CIRC.,
DELAYED
SWITCHOVER
3- DIR. CIR-
CUIT
4- COOLING
5- BOOST
6- BOILER
LOCKOUT
7- BURNER
COUNTER
1
S1.7 ANTI-BLOCK
FUNCTION
All outputs that haven’t been
activated in the last week are
activated on Friday between
20:00 and 20:15. for 60 seconds.
0- NO
1- YES
0
S1.8 REMOTE
ACTIVATION
VIA BUS
Selection if remote activation can be
activated only local or also from
master controller.
1- LOCALY
2- LOCALY &
FROM MASTER
2
S1.9
CIRCUITS
FOR REMOTE
ACTIVATION
Selection of circuits affected by
remote activation.
1- CIRCUIT 1
2- CIRCUIT 2
3- CIRCUIT
1 & 2
3
S1.10 BUILDING
TYPE (TIME
CONSTANT)
Selection of building type (time
constant). For heavy (thick walls )
and good isolated buildings select
higher value. For light (thin walls, no
heat accumulation) and poor isolated
objects select lower value.
0 ÷ 12 h 0
S1.13 SENSOR T1
CALIBRATION
Correction of displayed measured
temperature for sensor T1.
-5 ÷ 5 K 0
S1.14 SENSOR T2
CALIBRATION
Correction of displayed measured
temperature for sensor T2.
-5 ÷ 5 K 0
SERVICE PARAMETERS