Fast 9500, Руководство пользователя

Страница: 50 / 116

CONTROLS
CONTROLS Boom Sprayer 9500 / 9600 Page 50
CONTROLS
All functions on the sprayer are operated by
the Controllers mounted in the tractor cab. It
is recommended that all operators review
this section of the Manual to familiarize
themselves with the location and function of
all machine controls before starting. Refer to
the Manual supplied with the chemical
controller to familiarize yourself with the
calibration, operation, and troubleshooting
procedures for the chemical circuit.
Spray Circuit Controller
A micro-processor-based controller is
available to set, monitor, adjust, and display
several spray circuit parameters for the
operator. Review and follow the calibration
procedure at the start of the season and
when changing chemicals or nozzles.
Familiarize yourself with each controller
function and control before starting.
Chemical Circuit Controls
A. Flowmeter
B. Flow control
C. Section (Boom) valves
When an automatic circuit controller system
is selected, the monitoring components are
installed into the circuit next to the boom
solenoids.
Boom Function Control Box
Figure 13: 5-Function Box
Figure 14: 6-Function Box
This control box is mounted in the cab and
attached to a 12-volt power source. The
wiring harness is routed across the hitch and
plugs into the connector coming from the
trailer. Be sure that there are no power lines
next to the machine and that the machine is
in an open area large enough to allow the
booms to swing out without hitting any
obstructions. The hydraulic circuit control
lever to the boom function circuit must be
placed in detent prior to operating.