Ezgo REFRESHER 1200, Руководство пользователя

Страница: 47 / 146

OPERATION AND SERVICE INFORMATION
Page 27
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
SPARK PLUG
Tool List Qty. Required
Spark plug socket, 13/16", 1/2" drive .......................... 1
Ratchet, 1/2" drive....................................................... 1
Plug gauge, wire type ................................................. 1
Anti-seize compound ............................................... AR
Torque wrench, 1/2" drive, ft. lbs................................. 1
Use care not to over-tighten the plug. Over-tighten-
ing can cause damage to the aluminum cylinder
head threads.
Remove and inspect the spark plug at intervals indicated
in the Periodic Service Schedule (Ref Fig. 20 on page
18). The spark plug should be properly gapped (Ref Fig.
38 on page 27). Tighten to 16 ft. lbs. (22 Nm) torque.
Fig. 38 Gapping the Spark Plug
Fouled spark plug is indicated by a wet, black appear-
ance. This could be caused by a dirty air filter element or
other restrictions in the air intake system. Incorrectly
adjusted valves, spark plug wire which are in poor condi-
tion or poor quality fuel could also contribute to the prob-
lem.
PROLONGED STORAGE
To reduce the possibility of severe injury or
death resulting from a possible explosion:
Do not handle fuel in an area that is not
adequately ventilated. Do not smoke
near the fuel tank or refuel near open
flame or electrical items which could
produce a spark.
Store vehicle in a clean, dry area. Do not
store in same area as a stove, furnace,
water heater, or other appliance that
uses a pilot light or has a device that can
create a spark.
When refueling, inspect the fuel cap for
leaks or breaks that could result in fuel
spillage.
Always wear safety glasses while refuel-
ing to prevent possible eye injury from
gasoline or gasoline vapor.
Keep hands, clothing and jewelry away
from moving parts. Use care not to con-
tact hot objects. Raise the rear of the
vehicle and support on jack stands
before attempting to run the engine.
Preparing the engine for a prolonged storage period (30
days or more) calls for a few simple steps to prevent a
build up of varnish and gum in the carburetor and corro-
sion in the engine.
•
Raise the rear of the vehicle and support on jack
stands. Refer to ‘Lifting the Vehicle’ for proper lift-
ing procedure and safety information.
•
Disconnect the fuel hose at the fuel tank and plug
hose.
•
With proper ventilation, depress the accelerator
pedal and allow engine to run until it stops due to
lack of fuel.
•
Remove spark plug and pour about 1 oz. (30 ml)
of engine oil into the cylinder. Replace spark plug,
Fig. 37 Lubrication Points
Vista desde debajo del vehículo
Junta esférica
del soporte
Ref Lub 1
0.7 - 0.8 mm
(.028” - .031”)
Gap
Plug