Ezgo REFRESHER 1200, Руководство пользователя

Страница: 23 / 146

OPERATION AND SERVICE INFORMATION
Page 3
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
DRAIN VALVE INSTALLATION
Locate the drain hose ends and drain valve mounting
holes under the rear of unit. Orient each drain valve
assembly with spigot facing rearward. Attach each valve
assembly to unit with two 1/4 - 20 X 3/4" screws. Slide
the hose clamps onto the end of each drain hose. Push
the hose ends onto the drain valves and tighten clamps.
REFRESHMENT UNIT REMOVAL
The vending unit is heavy. Care and proper
lifting equipment and procedures must be
used when removing unit to reduce the pos-
sibility of severe injury and/or damage to
the unit. Be sure hands and fingers are clear
of unit while lowering.
The drain valves protrude below the frame of the unit
and can be damaged if the unit is removed from pal-
let and placed directly onto a flat surface. Remove
drain valves from refreshment unit before removing
unit.
Refreshment unit removal is the reverse order of installa-
tion. The unit should be lifted onto a pallet being careful
not to damage drains and then handled with a forklift. If a
forklift is not available, be sure an adequate number of
assistants are available to safely lift the vending unit and
pallet.
REFRESHMENT UNIT OPERATION, MAIN-
TENANCE AND CLEANING
Operation
Consumable ice must be stored in the rear
driver side compartment only. Clean this
compartment and the driver side drain valve
before and after each use to reduce the pos-
sible contamination of consumable ice.
Canned Beverage Compartments - The canned bever-
age compartments are designed to carry canned bever-
ages and cooling ice. Cold snacks (sandwiches, fruit,
candy etc.) can also be served from these compartments
by inserting the product into a plastic food container. Pre-
cooling the canned beverages will minimize the amount
of ice required to keep the product cool. Maintaining ice
in the canned beverage compartment when the container
is not in service will help to maintain a colder temperature
when the unit is put back into service.
Consumable Ice Compartment - The consumable ice
compartment, located in the rear driver side of the bever-
age container is to be used for consumable ice only (Ref
Fig. 1 on page 2). This compartment is equipped with it's
own drain per FDA requirements and should not be used
for canned goods or other products.
Trash Compartment - The trash compartment is located
in the rear of the vehicle. The aluminum trash bin should
be lined with a disposable plastic bag to maintain cleanli-
ness. The trash bin is removable from the rear door only.
Drains - The two spigot valves, located under the rear of
the beverage container, drain the compartments. To open
the valves, simply turn the valve handles away from the
vehicle (Ref Fig. 4 on page 5). To close the valves, turn
the valve handles to a position parallel with the vehicle. It
Fig. 2 Front Strut, Windshield and Mirror Installation
Ref Rfi 2
24
25
18
20
21
18
22
17
19
15
16
9
7
4
8
13
23
14
15
6
5
11
12
10
9