Extreme Networks ExtremeWare 7.3.0, Справочник по командам

Страница: 1702 / 2254

1702 ExtremeWare Software 7.3.0 Command Reference Guide
T1, E1, and T3 WAN Commands
configure ports snmp alert
configure ports <portlist> [t1 | e1 | t3] snmp alert [enable | disable]
Description
Enable and disable the sending of SNMP alerts for WAN links to the SMMi.
Syntax Description
Default
SNMP alerts are enabled by default.
Usage Guidelines
If the WAN module hardware detects a red, yellow, or blue alarm, the alarms are displayed by using a
show command. See the command “show ports alarms” on page 1741. Additionally, the module can be
configured to send an SNMP alert to the SMMi in the switch when red, yellow, or blue alarms are
detected. If the module is configured to send SNMP alerts, and the switch is configured to send SNMP
trap messages, then the switch will send a message to any SNMP trap receivers that have been
configured. To configure SNMP trap receivers, and for more information about configuring SNMP in
ExtremeWare, see the
ExtremeWare Software User Guide .
The module can also be configured not to send an SNMP alert to the SMMi. Any red, yellow, or blue
alarms will not be reported to the SNMP trap receivers.
Example
The following command disables snmp alerts from a port:
configure ports 4:1 t1 snmp alert disable
History
This command was originally available as “configure ports t1 alarms” in ExtremeWare v6.1.5w2.01WAN
technology release.
E1 support was added and the command was changed to “configure ports snmp alert” in ExtremeWare
v6.1.8w3.0.1b56 WAN technology release.
T3 support was added in ExtremeWare v6.1.8w3.0.1b61 WAN technology release.
This command was subsequently incorporated into ExtremeWare 7.0.0.
Platform Availability
This command is available on the Alpine 3800 series platform, when a WAN module is installed.
portlist A list of ports.