Extreme Networks ExtremeWare 7.3.0, Справочник по командам

Страница: 1867 / 2254

configure qostype ingress priority
ExtremeWare Software 7.3.0 Command Reference Guide 1867
configure qostype ingress priority
configure qostype ingress priority [diffserv | dot1p | vlan | application]
<qos-priority (0-15)>
Description
Configures the relative priority among the different ingress queue selection criteria.
Syntax Description
Default
• diffserv—3
• dot1p—1
• vlan—2
• application—5
Usage Guidelines
Ingress QoS types with a greater value take higher precedence.
The queue selection criteria with the highest priority, if enabled in the received packet, is used first,
followed by the remaining criteria in descending order.
The priority range is 0-15 (15 is the highest priority). Each queue selection criteria must have a unique
priority; no two selection criteria can have the same priority range.
All VLANs are set to the default ingress QoS profile none .
Congestion can cause ingress traffic to be dropped on oversubscribed
“3”
series I/O modules. Ingress
QoS allows received traffic with different VLAN priority values, different DiffServ code points (IP TOS),
or from different VLANS to be classified to up to eight different ingress queues. This allows for
specified traffic types to be queued separately so they remain unaffected by congestion in other ingress
queues.
To configure which DiffServ code points map to which ingress QoS profiles, use the command:
configure diffserv examination code-point <code-point> qosprofile <qosprofile> ports
[<portlist> | all]
diffserv Specifies the priority of the ingress queue based on DiffServ information. The
default is 3.
dot1p Specifies the priority of the ingress queue based on dot1p information. The
default is 1.
vlan Specifies the priority of the ingress queue based on VLAN information. The
default is 2.
application Specifies the priority of the ingress queue selection based on application
examination rules (IP protocol number and TCP/UDP port numbers). The
default is 5.
qos-priority (0-15) Specifies a priority value in the range of 0-15 (15 is the highest priority).