Extreme Networks ExtremeWare 7.3.0, Справочник по командам

Страница: 1020 / 2254

1020 ExtremeWare Software 7.3.0 Command Reference Guide
STP Commands
configure stpd tag
configure stpd <spanning tree name> tag <vlan tag>
Description
Assigns an StpdID to an STPD.
Syntax Description
Default
N/A.
Usage Guidelines
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
An StpdID is used to identify each STP domain. You assign the StpdID when configuring the domain.
An StpdID must be identical to the VLANid of one of the member VLANs in that STP domain, and that
VLAN cannot belong to another STPD. Unless all ports are running in 802.1d mode, an STPD must be
configured with an StpdID.
You must create and configure the VLAN, along with the tag, before you can configure the STPD tag. To
create a VLAN, use the
create vlan
command. To configure the VLAN, use the
configure vlan
command.
In addition to the VLAN attributes that you will use in the STPD, you must first create an STPD. To
create an STPD, use the
create stpd
command.
Example
The following command assigns an StpdID to the
purple_st
STPD:
configure stpd purple_st tag 200
History
This command was first available in ExtremeWare 6.2.
Platform Availability
This command is available on all platforms.
spanning tree name Specifies an STPD name on the switch.
vlan tag Specifies the VLANid of a VLAN that is owned by the STPD.