Extreme Networks ExtremeWare 7.3.0, Справочник по командам

Страница: 694 / 2254

694 ExtremeWare Software 7.3.0 Command Reference Guide
Commands for Status Monitoring and Statistics
enable log target
enable log target [console-display | memory-buffer | nvram | session |
syslog [<host name/ip> {:<udp-port>} [local0 ... local7]]]
Description
Start sending log messages to the specified target.
Syntax Description
Default
Enabled, for memory buffer and NVRAM; all other targets are disabled by default.
Usage Guidelines
This command starts sending messages to the specified target. By default, the memory-buffer and the
NVRAM targets are enabled. Other targets must be enabled before messages are sent to those targets.
Configuration changes to the
session
target are in effect only for the duration of the console display or
telnet session, and are not saved in FLASH. Others are saved in FLASH.
In earlier versions of ExtremeWare, a similar command was used to enable displaying the log on the
console. That command:
enable log display
is equivalent to:
enable log target console-display
Example
The following command enables log messages on the current session:
enable log target session
History
This command was first available in ExtremeWare 7.1.0.
console-display Specifies the console display.
memory-buffer Specifies the switch memory buffer.
nvram Specifies the switch NVRAM.
session Specifies the current session (including console display).
syslog Specifies a syslog target.
host name/ip Specifies the syslog host name or IP address.
udp-port Specifies the UDP port number for the syslog target.
local0 ... local7 Specifies the local syslog facility.